Volvo RTI Guía de instalación descargar pdf (Pagina 14)

Page

REM Power Cable

The REM power cable is intended for iMIV installations in the rear of the vehicle when there is no RTI

system present. The contacts are added into the brown fuse box connector and draws power through

the fuse box itself. It allows for an OEM type install with minimal difficulty.

WARNING!

THE IGNITION SWITCH MUST BE IN POSITION 0 THE KEY REMOVED BEFORE THE NEGATIVE BATTERY LEAD IS

DISCONNECTED. FAILURE TO DO SO WILL RESULT IN AN AIRBAG WARNING LIGHT. ALWAYS DISCONNECT THE

NEGATIVE LEAD OF THE BATTERY WHEN WORKING ON THE ELECTRICAL SYSTEM OF A VEHICLE.

WHEN THE WORK IS COMPLETE THE KEY MUST BE TURNED TO POSITION II BEFORE RECONNECTING THE NEGATIVE

BATTERY LEAD.

1) Start by removing the interior panel above the fuse box on the driver’s side of the trunk or

hatch. Consult your owner’s manual if you are unsure how to do this. The fuse box will look

similar to the image below. As stated, ensure you put the included 3 Amp fuse in location 17.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19

Sin comentarios

Volvo RTI Guía de instalación Pagina 14