Volvo D2 Series Manual del operador descargar pdf (Pagina 62)

Maintenance: Laying up and launching

Bringing out of storage

● Check oil level in the engine and drive/reverse

gear. Top up if necessary. If there is inhibiting oil

in the system drain and ﬁll with new oil, change oil

ﬁlter. For correct oil grade: See the chapter ”Tech-

nical Data”.

● Drain the antifreeze from the seawater system.

● Install the impeller in the seawater pump (replace

if the old one looks worn).

● Close/tighten drain cocks/plugs.

● Check drive belts.

● Check the condition of rubber hoses and tighten

hose clamps.

● Check engine coolant level and antifreeze protec-

tion. Top up if necessary.

● Connect the fully charged batteries.

● Paint the drive and hull: See next page.

● Check the sacriﬁcial anode on the drive. If there

is less than 50% of the anode left it must be

replaced. Clean with emery cloth just before the

boat is launched.

IMPORTANT! Do not use a wire brush or other

steel tools when cleaning, as these may dam-

age the galvanic protection.

● Reinstall the propeller.

● Launch the boat. Check for leaks.

● Vent and lubricate the propeller shaft seal (reverse

gear).

● Start the engine. Check that there are no fuel,

engine coolant or exhaust gas leaks and that all

control functions are operating.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 75 76

Sin comentarios

Volvo D2 Series Manual del operador Pagina 62